Boost Weak GPS Signals Below Deck
August 6, 2018
Digital Yacht will be exhibiting at Southampton Boat Show
Digital Yacht at Southampton Boat Show 2018 – Stand J417
August 20, 2018
Show all

Getting SeaTalk data in to a Racegeek d10

The Racgeek d10 is one of the hottest new products to appear on the yacht racing market for quite some time and we have been following its development with interest. A number of early adopters have wanted to get data from legacy Raymarine ST60+ and even older Autohelm ST50/ST60 instruments in to the d10 and we were only too pleased to be able to give them a solution with our SeaTalk to NMEA (ISO) Converter.

To make sure everything worked OK, we borrowed a d10 and hooked it up in our workshop to our ST-NMEA Converter. Then by sending simulated SeaTalk instrument data to our converter, we were able to make sure that all of the data was received by the d10, which we can happily confirm.

                                  

 

Interfacing our ST-NMEA Converter to the d10 is a very simple two wire connection and to make it even easier we have produced a wiring diagram.

 

 

2 Comments

  1. Jason Huffman says:

    Do you have this same diagram to connect to a Garmin NMEA 2000 network?

    • Paul Sumpner says:

      Hi Jason,
      To connect the Racegeek d10 to an NMEA 2000 network (Garmin or any other make), you would use one of our iKonvert ISO units rather than a SeaTalk converter as detailed in this post. The iKonvert ISO has an integral, NMEA 2000 drop cable which provides power and data to the converter and then has the same NMEA 0183 wiring colours as the SeaTalk converter so the wiring diagram in the post is identical.
      Hope this is useful.
      Best regards
      PAUL

Leave a Reply to Jason Huffman Cancel reply

Your email address will not be published. Required fields are marked *